i would favor to reposition part pot lights - prior to drywalling the ceiling. They have been wired making use of push-in cable connectors. Just how do you release the wires native a push-in wire connector ??


*

*

If you"re talking about an outlet - or a comparable concept fixture - the ideal tool I"ve uncovered is a level head jeweler/precision screw driver.

You are watching: How to remove push in wire connectors

The cable is being held in through this:

*

You can see you"ll have to push the "tab" far from the wire, from the ago of the outlet you have to see a little rectangle hole beside each circular hole the the wires are in:

*

MAKE sure POWER/BREAKER IS turn off YOU will certainly BE poignant A "LIVE" WIREInsert a tiny jeweler driver in the rectangle-shaped hole/slot, use the box as her pivot allude and the screwdriver as your level (bring back end the screwdriver towards wire to pressure "tab" away) and also gently traction the wire out.

* If the outlet is old/weak or the wire wasn"t placed in deep you deserve to sometimes acquire away with simply twisting the wire back and forth while pulling.


*

I to be guessing you are talking around something like what Halo has actually seen in the image below.

See more: Direct Flights From Memphis To Boston From $69, Cheap Flights From Memphis

*

To get these out you are an alleged to simply twist like hell and also pull out. Ns have had to traction a couple out in mine basement and also it bring away a minute. Likewise wear gloves since there space a most sharp edges around.

If you are going come rewire you must install a new connector. Stab relationships are not provided for re-use -- when you traction a wire out, their spring is weakened and also they cannot be relied ~ above to hold again. Reusing lock violates NEC 110.3b, the need to monitor labeling and instructions.

Note: my preferred an approach is to usage needle nose pliers and also grip about an inch from the connector. Then just jiggle and pull until it is lose. I have discovered jiggling enables me come not have to pull together hard.


*

*

Just twist the connectors ago and soon while pulling them turn off of the wires. That doesn"t call for too lot strength to do.


I just did this with my husband. Castle absolutely execute not traction out when they are in, yet he reduced the wire off leaving around 1/4" coming out of the connector. He handed it come me and also said, "See what you have the right to do" thinking we"d just have to gain a brand-new recessed irradiate fixture. I googled my inquiry in and also came come this website. Once I read the write-up where someone said twisting, ns went back, took my needle nose pliers, pulled turn off the plastic wire spanning so I might get a much better grip top top the wire. I didn"t need gloves...I didn"t have to work increase a lather and also I didn"t destroy anything. I realized the it had threads that maintained the wire from pulling out and simply and gently twisted it counter-clockwise and also it eased it"s means out! ours mistake was that my husband forgot to placed the wire through the punch the end holes in package of the recessed light fixture first! But, he got them through and poked the cable in the suitable holes that the connector and you couldn"t traction them out.